Sears Garage Door Opener Safety Sensor Bypass

When it comes to garage door opener safety, there is no compromise. However, some homeowners find themselves in a dilemma when their Sears garage door opener’s safety sensor fails and they are unable to open or close the door. Fortunately, there is an option for bypassing the safety sensors on a Sears garage door opener so that the door can still be operated.

The safety sensors on a Sears garage door opener provide important protection for both people and property. They detect any objects that are in the path of the closing door, and if one is detected, the door will stop and reverse direction. This prevents potential injuries and damage caused by a closing door. Unfortunately, if the safety sensors fail, the door will not open or close. This can be a major inconvenience, but bypassing the safety sensors on a Sears garage door opener can provide a solution.

Bypassing the safety sensors on a Sears garage door opener is not a difficult task, but it must be done with care. It involves disconnecting the sensors from the circuit board and then reconnecting the wires directly to the motor. This bypasses the safety sensors so the door can operate without them. It is important to note that while this will allow the door to open and close, it eliminates the safety protection provided by the sensors and could potentially lead to injury or damage. Therefore, it is essential that the process is carried out correctly and all safety precautions are taken.

It is important to note that bypassing the safety sensors is only a temporary solution. If the safety sensors have failed, they should be replaced as soon as possible to restore the safety protection they provide. Replacing the safety sensors on a Sears garage door opener is a relatively simple task and can be completed in just a few steps.

First, the power needs to be turned off to the door. This is done by either unplugging the power source or turning off the breaker switch. With the power disconnected, the sensors can be removed from the circuit board. This is done by unscrewing the screws that hold the sensors in place and then disconnecting the wires. Once the sensors are disconnected, the wires can be connected directly to the motor.

The next step is to reconnect the power to the door. This will allow the door to open and close without the use of the safety sensors. However, it is important to note that the safety protection provided by the sensors is eliminated and that caution should be used when operating the door.

Finally, the safety sensors should be replaced as soon as possible. This is done by simply reversing the steps that were taken to bypass them. The wires are reconnected to the circuit board and the sensors are secured in place. Once the sensors are reconnected, the safety protection is restored and the door can be operated normally.

Bypassing the safety sensors on a Sears garage door opener can provide a short-term solution to a failed safety system. However, it is important to note that this will eliminate the safety protection provided by the sensors and should only be done as a last resort. After bypassing the sensors, it is essential that they be replaced as soon as possible to ensure the safety of those using the door.

Bypass Garage Door Sensors From Sears Com